| 03-20-07 - The Birthday Inro - 002: At this phase the inner layer is cured, cut into sections, a bottom put on the middle section, aluminum foil applied where I don't want the outer layer to stick to the inner layer. This is when I cut the raw outer layer. I will cut to the bottom edge of the aluminum foil inside. Measure twice and cut once. This is where I usually screw up. Click here to see screen shots of this done. | ||
|
|
||
|
Home
Monthly Highlights Since 8/2003 | The official Clay Suppler for |
ComboTutes:
New and old stuff
First Three Years - Biz-Archive NJ Archive 1997-1999 |
